Garage door opener repair in Los Angeles
An opener that stops responding makes a simple morning hard. We look at the motor, the remote, the wall control and the safety sensors, and we say whether the opener needs a repair or a replacement.
- Motors, remotes and keypads
- Safety sensors
- Repair or replacement
When the opener stops, check the door too
An opener is a motor and a rail that pull the door along. Its remote and wall control send the signal, and a pair of safety sensors near the floor tell it when something is in the way.
Many opener calls turn out to be about the door itself. A door that is out of balance or stiff in its tracks makes the opener work harder than it should, and a broken spring makes it unable to lift at all.
So we look at the opener and the door together. If the opener is the problem, we repair it or fit a new one, and we test the safety sensors before we leave.
- Openers that hum, stall or will not start
- Remotes and keypads that stopped working
- Safety sensors that blink or block the door
- A door that reverses on the way down
- Replacement openers fitted and tested
What you get with Garage door openers
Door and opener together
A struggling opener is often fighting a stiff or unbalanced door. We check both before we blame the motor.
Safety sensors tested
We test the sensors that stop the door when something is in its path, so it behaves safely once the work is done.
Repair or replace
We say which makes sense for your opener, and we fit a new one if that is the better answer.
Remotes and keypads
Dead remotes, keypads and wall controls are part of the visit.
Signs the opener needs attention
These are the common ones.
- The motor hums but the door does not move
- The remote works only from close up
- The door stops or reverses partway
- Sensor lights blink or stay off
- Unusual grinding from the motor
What the visit covers
We start with the cheapest explanation and work outward.
We check the remote, the wall control and the power
We check the sensors and the door travel
We repair the opener or recommend a replacement
We test the controls and the sensors before we go
Replacing an opener
A replacement makes sense when the motor has failed or the opener no longer suits the door. We fit it to the door, set its limits and show you how the controls work.
Garage door openers questions
Why does my opener hum but not move the door?
A broken spring is a common reason. The opener cannot lift a door that has lost its spring, so the motor runs and the door stays put.
Why does the door reverse as it closes?
Often the safety sensors are misaligned or blocked, or the door is binding. We check both.
My remote stopped working. Is the opener broken?
Not necessarily. The remote battery, the wall control or the receiver may be the cause. We work through them.
Do you fit new openers?
Yes. We install a replacement when the old opener cannot be repaired or does not suit the door.
Other services we provide
Garage door springs
Broken springs, frayed cables and worn drums, replaced and tested so the door lifts evenly again.
Garage door repair
Noisy, slow or crooked doors, bent tracks, worn rollers and hinges, and damaged panels.
New garage door installation
A new door for the opening: chosen with you, fitted, balanced and set up with its opener.
The photographs are illustrative AI images, not jobs of ours.
Opener not responding?
Tell us what the door or gate is doing and leave your number. We call you back.